GL 350 BLUETEC (164.825) V6-3.0L DSL Turbo (642.820) (2010)
Wheel Hub: Procedures
AR33.20-P-0315-01GZ Pressing out and pulling in front axle shaft flange
Modification Notes
Special Tools
Component Identification
Press out front axle shaft flange
1
Position upright (1) and press out tool on workshop press.
Use suitable horizontal base for support during pressing procedure.
2
Press front axle shaft flange (9) out of the steering knuckle (1) by operating the workshop press.
Check that the press out tool has been correctly positioned on the front axle shaft flange (9).
Press in front axle shaft flange