GLK 350 4MATIC (204.987) V6-3.5L (272.971) (2010)
Air Bag Control Module: Recalls
Campaign - Update SRS Control Module Software
FILE:
SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER
PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER
Campaign No. 2010030001, May 2010
Revision
Date
Purpose
A
05/26/10
Revision to Procedure and Warranty information. Parts information included.
-
03/05/10
Initial issue
TO: ALL MERCEDES-BENZ CENTERS
SUBJECT: Model 204.9, Model Year 2010
Supplemental Restraint System (SRS) - Update Control Module Software
Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined the possible illumination of the SRS light following vehicle start. The
functioning of the SRS is not impaired. An update to the software of the SRS control module software is available to correct this condition. Dealers will
update the Supplemental Restraint System (SRS) software at the next workshop visit. If the initial startup is interrupted, as outlined in the work
instructions, the SRS control module is to be replaced
Prior to performing this Service Campaign:
^ Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.
^ Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.
Please note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.
Approximately 7,693 vehicles are affected.
Procedure
Note:
^ Use Xentry 01/10 with all associated patches or higher.
^ Follow the steps exactly as described in Xentry.
^ Connect battery charger (battery voltage >12.5V).
^ The vehicle must have SRS control module hardware version 08/24 for 204 870 70 26 in order for the flash to be valid for the campaign.
^ If the SRS software is version 08/24 00 the campaign has not been performed. If the SRS software was previously updated it would indicate SRS
software 9/16 00
A. Perform Initial Startup in SRS Control Module
1. Connect Star Diagnosis to vehicle.
2. Perform initial startup in SRS control module: Select: Initial Startup with manual adjustment of new control unit (follow on-screen instructions).
Note:
Be sure to perform SCN coding.