ML 320 (163.154) V6-3.2L (112.942) (1998)
Keyless Entry Module: Service and Repair
Remove/Install Drive Authorization Module (FBM)
Remove/Install
1
Remove Extended-Activity-Module (EAM) (2)
2
Loosen the retaining lugs (3) which hold the DAS control module (5) in the EAM
CAUTION: Ensure that the retaining lugs do not break off.
NOTE: Use radio removal tools (4) for removal.
3
Remove the DAS control module from the EAM
NOTE:
-
Before installing a new DAS control module, determine in the old DAS control module whether keys are banned and code suitably in the new
DAS control module.
-
The chassis number must be stated when ordering a new control module.
4
Install in the reverse order
5
Move ignition key into position 1 for at least 40 seconds.
6
Check whether the vehicle can be started with all keys