ML 320 (163.154) V6-3.2L (112.942) (1998)
7
Insert oil dipstick as far as the stop and pull out again, read off oil level and repeat if necessary
NOTE: Warm up the transmission, wait at least 2 minutes and check the oil level with the engine running.
CAUTION: If too much transmission oil is added, it is absolutely essential to drain off or extract the surplus. Insufficient and excessive
quantities of oil result in malfunctions and transmission damage.
8
Check oil level again
-
Correct if necessary
9
Fit cap (93) on oil filler pipe and press in new locking pin (93a) until it clicks into place
10
Check transmission for leaks
CAUTION: In the event of oil loss determine and eliminate cause, otherwise it may result in both malfunctions, transmission damage and
serious harm to the environment.