ML 430 (163.172) V8-4.3L (113.942) (2000)
Shift Interlock Cable: Service and Repair
AR27.60-P-0122GH Ignition Switch Control Cable
Removing And Installing Ignition Switch Control Cable
Transmission 722.6
163 #A as of 145273
163 #X as of 708319
1
Disconnect ground cable of battery
2
Remove center console
3
Remove cover below instrument panel (left)
4
Press locking tabs (1a) together and detach ignition switch control cable (1) from ignition/starter switch (S2/1)
NOTE: Installation: move ignition switch to position "0".
Function test:
-
It must only be possible to move the selector lever out of position "P" when the ignition switch is in position "2" and the brake pedal is
depressed.
-
It must only be possible to withdraw the ignition key when the selector lever is in position "P".
5
Release ignition switch control cable (1) at electronic selector lever control module (N15/5).
NOTE: Press locking tab (1b), twist coupling (1c) through 90 degrees in direction of arrow and pull off ignition switch control cable (1).
6
Remove ignition switch control cable (1) from instrument panel.
NOTE: Unclip ignition switch control cable (1) from clip (2).
7
Install in the reverse order.