ML 430 (163.172) V8-4.3L (113.942) (2000)
Component Illustration
CAN data bus
Input signals:
Selector lever position (from potentiometer (90))
Touch button +/
Voltage supply (terminal 87)
Power supply for reverse lamp (terminal 15)
Signal for shift gate illumination (terminal 58d)
Kickdown switch (S16/6)
Stop lamp switch (S9/1)
Input and output signals:
Datalink connector (X11/4)
Output signals:
R/P lock solenoid valve (89)
Power supply and ground for potentiometer
Reverse lamp (via the light module (N7-1))
Via the engine compartment bus, there are connections to the:
ETC control module (N15/3)
Traction system control module (N47)
The following information is received:
Traction system control module (N47)
Rear right wheel speed
Rear left wheel speed
The following information is sent:
ETC [EGS] control module (N15/3)
Selector lever position
Kickdown switch (S16/6)
Touch button +/-
Design
The selector lever module (N15/5) consists of
a printed circuit board
two contacts at the button for recognizing the selected
shift range (b)
two plugs (A, B)
four LEDs to illuminate the shift gate (a)