R 350 BLUETEC (251.125) V6-3.0L DSL Turbo (642.870) (2010)
Component Identification
Install
5
Assemble hollow cylinder (13), hydraulic hose (14) and hand pump (15).
6
Fit front plate (M) and front rubber mount (10) on to the hollow cylinder (13).
7
Feed threaded spindle (12) through the hollow cylinder (13), front plate (M), front rubber mount (10) and the rear axle carrier (11), and screw on
nut block (F).
Be careful when screwing on the nut block (F). Otherwise the paint work on the rear axle carrier (11) can be damaged.
8
Align front rubber mount (10) with markings and press in.
Use lubricant The pressure in the hand pump (15) must not exceed 140 bar.