S 320 LWB (140.033) L6-3.2L (104.994) (1995)
Replacement
1. Remove camshaft.
2. Pry out cover (1) with a screwdriver.
3. Clean hollow-drilled camshaft (26).
4. Inspect bore (B).
5. Knock in end cover (1) with drift (2) (shop.made tool).
6. Reverse procedure to install, noting the following:
-
Use new end cover (1).
-
The end cover must not be seated on the end of the bore.
-
It is essential to maintain the insertion depth (size E).
Specifications
Bore (B): 14.00 - 14.04 mm
Camshaft (26): inlet, exhaust at rear
End Cover DIN 443 (1): A14
Insertion Depth Size (E): 9.3 mm
Inspection Drift (2) Dimensions:
d: 11.7 mm
D: 13.7 mm
H: 4.3 mm
r: 1 mm
r1: 35 mm
Replacing Threaded Bush In Front of (Exhaust) Camshaft
Exhaust Camshaft Bush Replacement
1. Remove camshaft.
2. Unscrew threaded bush (1).
3. Clean hollow drilled camshaft (26).
4. Clean and remove grease on thread at front of camshaft (26).
5. Replace threaded bush (1) (micro-encapsulated).