S 320 LWB (140.033) L6-3.2L (104.994) (1995)
13. Slacken bolts (3 and 4) and unscrew. Swivel bracket (213). Unscrew bolts (1) for bracket of combination support (2).
14. Unscrew air pump from bracket (remains on vehicle with pipes connected).
15. Unscrew bolts (214, 214a) and remove fan bearing bracket (217). Unscrew nut (99). Take off TDC sensor (100) together with cable and place to
the side.
NOTE:
TDC sensor bracket (102) remains on timing case cover.
If timing case cover is replaced, set TDC sensor. Refer to Powertrain Management - Computers and Control Systems - Crankshaft
Position Sensor - Service and Repair - Procedures
16. Unplug cable connector at generator.
17. Unbolt generator together with support and take off.
Installation Note: Insert side and front bolts for support until they make contact. Tighten front bolts first of all so that support is installed free of stress.
18. Unbolt timing case cover in crankcase and oil pan.
19. Detach timing case cover together with bracket of TDC sensor.
NOTE:
Do not damage oil pan gasket!
If necessary, replace oil pan gasket.
Examine radial seal; replace, if necessary.
20. Clean sealing surfaces of crankcase and of timing case cover. Apply an even coating of sealant 002 989 47 20 to me sealing surface of the timing
case cover.
NOTE:
The timing case cover is fixed in place by two roll pins on me crankcase.
Pay attention to projection of 6 mm (arrow).
Do not damage oil pan gasket.
First of all, tighten bolts of oil pan, tightening torque 10 Nm.
Timing case cover to crankcase: