S 320 LWB (140.033) L6-3.2L (104.994) (1995)
/l6-3.2l_(104.994)/Page-1839013.png)
-
Unscrew screw plug, screw in, 45 - 55 Nm, replace seal (72).
-
Remove compression spring (70) and spring pin (69) in turn from steering gear housing, insert.
-
Check compression ring (70).
-
Examine spring pin (69) for signs of wear, replace, if necessary.
NOTE: The play compensator is only effective in the center area of the steering gear. If a complaint is received about excessive steering play, the
steering gear friction torque should be reset. See: Checking and Adjusting Friction Torque of Steering Gear
Procedural Overview
Procedural Overview
For information about special tools contained within the procedures, See: Tools and Equipment Actual procedures for the operations below are given
in more detail in "Procedure (Steps)" and they should be used as the primary reference when performing the repairs explained within it. See: Remove
& Install Shaft/Bearing Cvr, Replace Radial Seal Ring/Procedure
Preceding work:
Removing and installing steering gear.
Removing and installing bearing cover/pitman arm shaft
Removing and installing play compensator.
A. Steering Shaft/Bearing Cover with Locking Ring (up to 10/87):
