S 500 4MATIC (220.184) V8-5.0L (113.966) (2003)
-
Installation: Replace hexagon collared nut and tighten in stages until the previously measured friction torque is obtained.
-
Installation: Secure twelve-point or hexagon collared nut on drive pinion joint flange.
10
Pull off joint flange (41)
11
Press out radial seal (42) using a suitable tool
CAUTION: Installation: Replace radial sealing ring and coat sealing lip with universal hypoid gear oil
12
Replace final-drive unit (55) vent
13
Install in the reverse order
14
Check rear final-drive unit oil level and correct if necessary.