S 500 Coupe (140.070) V8-5.0L (119.980) (1997)
3. Unscrew right rear brake pad wear sensor connector (S10/4x1)
4. Unscrew micro-encapsulated bolts (35) then remove fixed caliper (31) from wheel carrier.
Installation:
5. Install in reverse order, noting the following.
-
Replace micro-encapsulated bolts (35), tighten to:
Model 210.072 with Code 957 (E50 AMG): 50 Nm
NOTE:
^
Install the transparent (temperature-resistant) version of the brake pad wear sensor (S10/4).
^
The wear sensor on the rear fixed caliper is not used anymore on model 202.028 with ASR as of 09/95.
-
Tighten brake pipe (5) on brake hose (51) to: 18 Nm
-
Tighten brake hose (51) on fixed caliper (31) to: 18 Nm
-
Refer to Replacement, for notes on installing brake hoses. See: Brake Hose/Line/Service and Repair
-
Refer to notes on installing brake pad wear indicator contact sensors. See: Brake Warning Indicator/Brake Pad Wear Sensor/Service and
Repair
6. Bleed brake system. See: Brake Bleeding/Service and Repair
7. Check brake system for leaks, refer to Using Pedal Pressure. See: Testing and Inspection