S 55 AMG (220.174) V8-5.5L SC (113.991) (2004)
Garage Door Opener Transmitter: Customer Interest
Accessories - Can't Program Garage Door Opener
Date: December 19, 2008
Order No.: S-B-68.05/47a
Supersedes: P-B-68.05/47 dated April 11, 2006
Group: 68
Revision History
SUBJECT:
All Passenger and Light Truck Models
Garage Door Opener Cannot be Programmed
If you receive customer reports in the above model vehicles of the integrated garage door opener on the interior rearview mirror or overhead control
panel unable to accept coding from a hand-held garage door transmitter, this may be caused by the integrated garage door opener being preprogrammed.
You can determine if the system has been preprogrammed by pressing a signal transmitter button. The indicator lamp will illuminate but will not flash.
To resolve, please refer the customer to the instructions noted in the Operator's Manual on erasing the integrated remote control memory. Attached is a
copy of the instructions that can be provided to the customer.
NOTE:
The enclosed procedure cannot be claimed under Warranty.
Instructions on Resetting the Integrated Remote Control Memory
1. Switch on the ignition.
2. Simultaneously press and hold down the outer signal transmitter buttons (Figure 1 or 2, 2 and 4) for approximately 20 seconds until the indicator
lamp (Figure 1 or 2, 1) flashes rapidly. Do not hold for longer than 30 seconds.