S 55 AMG (220.174) V8-5.5L SC (113.991) (2004)
Engine Mount: Service and Repair
AR22.10-P-1260A Remove/Install Front Engine Mounts and/or Engine Brackets
Remove/install front engine mounts and/or engine support
Right engine side (removal of engine mount and engine support)
1
Disconnect ground lead from battery
NOTE: Turn key in electronic ignition switch EIS into position "0". Key cannot be withdrawn.
NOTE: Vehicles with Keyless-Go code 889: Switch off engine, remove Keyless Go cards from the vehicle and keep outside the range of the
transmitter.
CAUTION: Do not connect quiescent current retention unit. A short circuit could occur if the electrical line circuit 30 (B+) comes into
contact with ground.
2
Remove bottom engine compartment paneling
3
Unclip cover at front end of engine.
4
Remove air cleaner housing with air intake pipes (1)
5
Remove ribbed V-belt.
6
Disconnect electrical lines at generator (G2).
NOTE: Installation: Observe installation position of lines.
7
Dismount generator (G2) and place in the engine compartment to the side.
8
Fit on engine supporting frame.
9
Unscrew bolts of engine mount (5) to front axle carrier
NOTE: Unscrew on both sides.
CAUTION: The anti-twist locks in the front axle beam must latch into the retaining grooves of the engine mount (8, 9).
10
Raise engine at front lifting eye.
CAUTION: Ensure that the rear of the engine does not touch the body.
11
Dismount right engine support (11) at crankcase, for this step unscrew bolts (12) and take out right engine support (11) with engine mount (9)
toward front.
CAUTION: Installation: Replace bolts (12).