S 600 (220.176) V12-5.5L Turbo (275.960) (2005)
Fuse Block: Service and Repair
AR54.21-P-1260I Remove/Install Sam Control Module With Fuse and Relay Box, Front Left
AR54.21-P-1260I Remove/Install Sam Control Module With Fuse and Relay Box, Front Left
Shown On Model 220
Removal, installation
1
Connect quiescent current retention unit
2
Disconnect ground lead from battery
3
Open engine hood and move to upright position
4
Release and remove cover on left fuse box (F1)
5
Fold up clamping lever (1) and remove supply cable (terminal 30)
6
Unclip fuse carrier (2) on control module unit (driver-side SAM control module (N10/6) with left front fuse and relay module (K40/6)).
NOTE:
-
Once the retaining lugs (arrow) have been pressed in the direction of the arrow, the fuse carriers can be taken out from the top.
-
The components fitted to the left front fuse and relay module may vary depending on the equipment.
7
Remove the remaining couplings on the left front fuse and relay module
8
Pull out control module unit from above
CAUTION: Only pull out until the couplings (3) on control module unit (left front fuse and relay module (K40/6) and driver-side SAM
control module (N10/6)) are accessible
9
Unlock and remove couplings (3)
-
If driver-side SAM control module or left front fuse and relay module are defective: Disconnect SAM control module from fuse and relay
module
10
Install in reverse order.