S 600 Sedan (140.057) V12-6.0L (120.982) (1996)
Removing and installing wire cable/steering lock
1
Remove cover below left of instrument panel
2
Unhook wire cable/steering lock (79) by pressing in the locking tongues and at the same time pressing (arrows) against the steering lock (figure A)
Installation: Position key in steering lock in position "1"
3
Remove stop lamp switch
4
Unhook wire cable/steering lock (79) at the release lever (77)(arrow)(figure B)
5
Compress locking device (arrows) and at the same time push the wire cable/steering lock upwards out of the mount on the pedal bearing bracket
(figure C)
6
Remove wire cable/steering lock
7
Install in reverse order
8
Adjust wire cables for parking lock interlock
Refer to Adjustments See: Adjustments
Removing wire cable/transmission
9
Remove cover below left of instrument panel
10
Pull off entrance strip upwards
11
Remove A-pillar footwell cover
12
Unscrew accelerator pedal from floor panel
13
Remove driver side floor lining complete
Note: Do not fold up carpet, foamed insulating material cracks
14
Remove air duct for rear compartment heating
15
Unhook wire cable/transmission (80) at release lever (77)(arrow)(figure B)
16
Compress locking device (arrows) and at the same time push the wire cable/transmission upwards out of the mount on the pedal bearing bracket
(figure C)