S 65 AMG (221.179) V12-6.0L Turbo (275.982) (2008)
1.
Remove seatback lining (A, Figure 2) from backrest of left front seat.
^
Detach two bolts (B) at bottom and pull seatback lining downwards.
2.
Disconnect feed line and close off with stop plug (part # A 124 805 02 44) as shown in Figure 3.
3.
Perform leak test.
^
Follow the DAS menu Pump control unit-> Complete list of guided tests-> Check entire system for leaks."
4.
Perform one of the following, depending on results of leak test in previous step:
^
If no pressure loss is detected: Perform Procedures G and H.
^
If pressure loss is detected: Repeat procedure on right seat.
Note:
If no malfunctioning padding was discovered during the test of the front seats, Procedure C must be performed on the rear seats.
C.
CHECK SYSTEM FOR LEAKS (REAR SEATS)
1.
Remove left rear seat backrest; refer to WIS document AR91.12-P-1620SX.