mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

GF91.60-P-1100SX Passenger-Side Seat Occupied Recognition Function|Page 13859 > < GF91.60-P-1100SX Passenger-Side Seat Occupied Recognition Function|Page 13857
Page 2
background image

Automatic child seat recognition airbag OFF indicator lamp (S6/2e1)

The signal for switching the airbag OFF indicator lamp on when a child seat is detected is transmitted to the central gateway control unit (N93) by the
restraint systems control unit via the chassis CAN and then to the upper control panel control unit (N72/1) via the interior CAN. This then relays the
signal to the cockpit switch group (S6/2) via the upper control panel LIN.

Error messages

If the seat occupied and child seat recognition sensor is defective or communication with the restraint systems control unit is interrupted (e.g. plug not
connected), the airbag OFF indicator lamp is also switched on. A fault is also stored in the restraint systems control unit and an appropriate message is
shown on the instrument cluster (A1).

If the child seat is defective or wrongly positioned (only one resonator detected), the airbag indicator and warning lamp (A1e15) in the instrument cluster
and the airbag OFF indicator lamp are switched on.

GF91.60-P-1100SXU Front Passenger Seat Occupied Recognition Sensor, Function

GF91.60-P-1100SXU Front passenger seat occupied recognition sensor, function

- with CODE (494) USA version

WSS (Weight Sensing System)

The front passenger seat occupied and automatic child seat recognition are determined by means of the weight that is on the front passenger seat.

The WSS sensors (B48/11, B48/12, B48/13 and B48/14) determine the weight (person or child seat) on the front passenger seat. The force that is
introduced via the seat belt is measured by the belt tension sensor (B48/3) so that weight classification corrections can be made if necessary.

These two measurements are used by the Weight Sensing System (WSS) control unit (N2/13) to calculate a weight classification for the weight on the
seat, which is then transmitted to the central gateway control unit (N93) via the interior CAN and then relayed to the restraint systems control unit (N2/7)
via the chassis CAN.

The following conditions are defined depending on the weight classification:

^

Seat unoccupied:
the front passenger airbag unit, front passenger sidebag unit and front passenger belt buckle emergency tensioning retractor unit are disabled

^

Seat occupied:
-

Light weight (e.g. child seat) and belt applied:
Front passenger airbag unit switched off

-

Person detected:
Front passenger airbag unit enabled (ignition of first or both stages)

The signal is also transmitted to the instrument cluster (A1) via the interior CAN, and an appropriate message appears in the multifunction display
(A1p13).

Automatic child seat recognition airbag OFF indicator lamp (S6/2e1)

If the front passenger seat is found to be occupied, the automatic child seat recognition airbag OFF indicator lamp in the cockpit switch group (S6/2) is
switched off.

If the front passenger seat is found to be unoccupied, the airbag OFF indicator lamp is switched on.

If a light weight is detected and the latch plate has also been inserted, the airbag OFF indicator lamp is switched on as well as the multifunction display in
the instrument cluster.

The signal for switching the airbag Off indicator lamp on or off is relayed to the central gateway control unit via the chassis CAN by the restraint systems

GF91.60-P-1100SX Passenger-Side Seat Occupied Recognition Function|Page 13859 > < GF91.60-P-1100SX Passenger-Side Seat Occupied Recognition Function|Page 13857