S 65 AMG (221.179) V12-6.0L Turbo (275.982) (2008)
Crossmember And Front Reinforcement
Correct articulation angle in the center (2)
To correct the inclination angle, install the shop-made shims at the propeller shaft center support bearing. A 1 mm thick shim changes the inclination
angle by approx. 0.17 degrees.
When using shims > 2 mm thick, increase the bolt length by 5 mm.
If a shim > 5 mm thick is required, check the front engine mount and rear engine mount for signs of settling or wear and replace if necessary.
Component Identification
1
Detach crossmember (31).
Shows on model 211