mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Power Window Lockout Switch > < Body - Power Window(s) Are Inoperative
Page 1
background image

Power Window Control Module: All Technical Service Bulletins
Body - Power Window(s) Are Inoperative

Date: September 17, 2008

Order No.: P-B-67.39/22b

Supersedes: P-B-67.39/22a dated August 11, 2008

Group: 67

Revision History

Revision

Date

Purpose

b

9/17/08

SDS Version Updated / Remedy Revised

a

8/11/08

Damage Code Revised (Rear Left or Right)

-

01/07/06

Initial issue

SUBJECT:
Model 216.371/376/377/379, Up to VIN A010649
Model 221.171/176/177/179, Up to VIN A161249

Power Window Not Functioning

If you receive customer reports in the above model vehicles of the power window in any door not functioning and exhibiting the below symptoms, this
may be due to a software error in the door control module.

^

The temperature will fluctuate greatly (+10°C or -10°C) when actuating the window. To check, using Star Diagnosis (SDS) via menu path: Control
units --> Seats and doors --> DCM-XX - Door control module (Choose DCM with the issue) --> Actual values --> Power window --> Thermal fuse,
monitor the "temperature power window motor" while actuating the window.

^

For door control modules with diagnosis identifier 09 or later the fault code 9066, "Control unit N69/X (XXXX XXXX door control unit) is
defective", will be stored in the fault memory. Diagnosis identifier can be seen at SDS via menu path: Control units --> Seats and doors -->
DCM-XX - Door control module (Choose DCM with the issue) --> Control unit version.

To resolve, flash the applicable door control module using SDS version 08/08 or later, via SDS menu path: Control units --> Seats and doors -->
DCM-XX - Door control module (Choose DCM with the issue) --> Control unit adaptations --> Control module programming. Do not replace any
parts.

Note:

The following allowable labor operations should be used when submitting a warranty claim for this repair. This information has been generated on
August 11, 2008. Please refer to Netstar --> Star TekInfo --> Star Time for the most current labor time allowance.

In Case of Warranty, use the table.

Power Window Lockout Switch > < Body - Power Window(s) Are Inoperative