mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Adjust Ball Point Position|Page 6675 > < Adjust Ball Point Position|Page 6673
Page 16
background image

NOTE:  Numbers in parentheses ( ) indicate a component or tool in the associated illustration.

1. Check vehicle level at the front and rear I axle
2. Adjust toe-in at rear axle carrier (50) using the cam bolt (60a) on the mount of left and right track rod (60)

-

Toe-in of rear wheels:
-

Range: 0.33 to 0.58°

-

Preferred: 0.42°

3. When adjustments are complete, tighten, cam bolt of rear axle track rod to: 70 Nm

Checking Ball Point Position

Checking Ball Point Position

NOTE:  Numbers in parentheses ( ) indicate a component or tool in the associated illustration.

1. Install measuring device (01) tool No. 210 589 00 21 00 in the wishbone bolted connection and position on "0" on the scale by means of a plum

bob

2. Check ball point position in the straight ahead position of the front wheels

-

Slide (01b) on track rod

-

Specification:
-

Range: 21 to 25 mm

-

Desired: 23 mm

3. If the ball point position is outside tolerance, refer to Adjustments

General Information, Chassis Alignment Check

Adjust Ball Point Position|Page 6675 > < Adjust Ball Point Position|Page 6673