SL 500 (129.068) V8-5.0L (113.961) (2000)
/v8-5.0l_(113.961)/Page-2108003.png)
3. Drive out clamping sleeve
-
If tightly seated, drill out clamping sleeve halfway
4. Drive rubber mount out of control arm using a suitable drift
INSTALLATION
1. Thoroughly clean mounting bore for rear mounting in control arm
-
Rub down with emery cloth if necessary
2. Coat circumference (arrow) of rubber mount and mounting bore in control arm with suitable lubricating fluid, e.g. Naphthalene part No. 000 989
14 60, or equivalent soft soap
CAUTION: Do not use oil or grease
Installed Position Of Rubber Mounts (Rear Mounting)
3. Install the rubber mounts in the rear mounting so that the flats (arrows) are vertical
Installed Position Of Rubber Mounts (Front Mounting)
4. Install the rubber mounts in the front mounting so that the flats (arrows) are horizontal
CAUTION:
