SL 500 (230.475) V8-5.0L (113.963) (2004)
11
Pull floor covering (6.1) out below instrument panel (5), lift at rear and remove from vehicle
12
Prepare floor covering (6) for installation
CAUTION: Before installing floor covering (6.1) dean passenger compartment in area of floor covering.
NOTE: When replacing floor covering (6.1) cut new floor covering (6) with sharp knife along dotted line and remove section (shaded area)
below heater system.
Install
13
Install floor covering (6.1) in passenger compartment and position
NOTE: Guide cut edges in front area below instrument panel (5) (arrows), simultaneously route wiring harness (7) for driver's seat and screwed
bolts for accelerator pedal.
14
Insert A-pillar paneling at bottom left and tighten screw
15
Install accelerator pedal
16
Install cover below instrument panel (5) (left)
17
Install cover on center console
18
Install stowage box (3)
19
Install belt buckle (2) in left rear
20
Install side paneling (1) in left rear
21
Install front seat on left