SL 500 (230.475) V8-5.0L (113.963) (2004)
Shown On Engine 113.991, Part 3
1
Connect quiescent current retention device
DANGER:
-
Risk of explosion from explosive gas. Risk of poisoning and caustic burns from swallowing battery electrolyte. Risk of injury through
burns to skin and eyes from battery acid or when handling damaged lead-acid batteries.
-
No fire, sparks, naked flames or smoking.
-
Wear protective gloves, acid-resistant clothing and safety glasses. Pour battery electrolyte only into suitable and appropriately
marked containers.
2
Disconnect ground cable of battery
NOTE:
-
Turn key in electronic ignition switch EIS into position "0". Key cannot be withdrawn.
-
Vehicle fitted with code (889) Keyless-GO: Switch off engine, remove Keyless Go cards from the vehicle and keep outside the range of the
transmitter.
-
Installation: Read out fault memory after connecting, adjust time display on combination instrument, code radio, normalize power window
and activate steering angle sensor.
-
Vehicles with stationary heater: Adjust time display on stationary heater.
3
Unclip and remove engine cover (8)
4
Slacken coolant expansion tank and place to the side
5
Remove air intake pipe
NOTE: Only on right-hand side.
6
Remove poly V-belt of supercharger
NOTE: Only model 211.076, 215.374, 220.074, 230.474.
7
Remove poly V-belt
8
Pinch off electrical connections of generator
9
Unscrew bolts (1) and place generator (G2) to the side
10
Take chain tensioner (6) off timing case cover (5)
NOTE: Installation: Replace seal (7).
11
Install in the reverse order
12
Render electrical system operational
NOTE: Perform basic programming (normalize windows and sliding roof, etc.).