SL 500 (230.475) V8-5.0L (113.963) (2004)
Power Distribution Module: Service and Repair
AR54.21-P-0100R Remove/Install Vehicle Power Supply Control Module
- except CODE (P99) "AMG Black Series" special model
1
Close Vario roof fully with the Vario roof switch
NOTE: See Operating instructions
2
Connect STAR DIAGNOSIS and store the basic data from the vehicle power supply control module (N82/1) in STAR DIAGNOSIS on an
intermediate basis
-
Only when replacing the vehicle power supply control module (N82/1).
NOTE: Installation: Transfer basic data stored on an intermediate basis to the new vehicle power supply control module (N82/1).
3
Disconnect ground leads from battery
4
Remove side paneling in trunk
NOTE: Only remove the right paneling.
5
Unclip cover (1)
6
Unscrew nut (2) and remove the electrical lines (5) from the vehicle power supply control module (N82/1)
NOTE: Installation: Observe installation sequence of electrical lines (5).
7
Unscrew nut (4) and remove electrical lines (3) from the vehicle power supply control module (N82/1)
NOTE: Installation: Observe installation sequence of electrical lines (3).
8
Disconnect plug and socket connection (6)
9
Unscrew nuts (7) and remove vehicle power supply control module (N82/1)
10
Install in the reverse order.