SL 500 (230.475) V8-5.0L (113.963) (2004)
Component Identification
Attach retaining clamp to connector
The safety clamp (2a) must be replaced after every disconnection of a transmission oil line (1).
5
Introduce one end of the safety clamp (2a) into a cutout (2b) on the connector (2).
6
Push retaining clamp (2a) in the direction of the arrow until the retaining clamp (2a) clicks into place in the connector (2).
Component Identification
The securing clamp (2a) must not be pushed straight (radially) over the connector (2) otherwise the securing clamp (2a) will be overstretched and
correct sealing of the line connection is no longer guaranteed.
Attach transmission oil line to connector
The dust cap (3) must be replaced after every disconnection of a transmission oil line (1).
7
Push dust cap (3) onto the transmission oil line (1).
8
Introduce transmission oil line (1) straight into the connector (2) until it audibly and noticeable latches.
9
Push dust cap (3) onto the connector (2) until it latches and can turn freely.
If the dust cap (3) cannot be pushed over the connecting point then the transmission oil line (1) is not fully latched in the connector (2) or the
safety clamp (2a) is overstretched.
AR27.55-P-0600RBS Remove/Install Oil Lines of Oil Cooling For Automatic Transmission
AR27.55-P-0600RBS Remove/install oil lines of oil cooling for automatic transmission