SL 500 (230.475) V8-5.0L (113.963) (2004)
Component Identification
2
Using sleeve (01), thrust piece (02), spindle (03) and nut (04) pull rubber mount (62) out of the rear axle carrier (1) towards the front of the
vehicle.
Component Identification
Install rubber mounts
The flat contact surface of the rubber bushing (62) must point towards the vehicle front.
3
Position rubber bushing (62) on the rear axle carrier (1) from the front and draw into the rear axle carrier (1) using sleeve (05), thrust piece (06),
spindle (03) and nut (04) until the protrusion measured previously is reached.