SL 600 (129.076) V12-6.0L (120.981) (1995)
Top .................................................................................................................................................. move to position A with top switch or manual actuation
Screw (1) .......................................................................................................................................................................................... screw out of cable guide
Plug connector (S84/6x) ......................................................................................................................................................................................... disconnect
Top ............................................................................................................................................................................................................ move to position B
Ignition .................................................................................................................................................................................................................... switch off
Cloth holding brace .......................................................................................... press in direction "closed" until screws (2) can be reached with screwdriver
Screws (2) ................................................................................................................................................................................................................ screw out
Limit switch (S84/6) ..................................................................................................................................................................... remove together with cable
Installation
Install in opposite order
NOTE:
Lay limit switch cable along flexible hydraulic lines
Adjustment
Connect multimeter to plug connector (S84/6x). Set multimeter to continuity test (acoustic signal).
Adjust limit switch (S84/6) by moving in oblong holes.
Limit switch (S84/6) should switch approx. 100 mm before reaching the uppermost position of the cloth holding brace.
Top Up (Differential Operation)
Removal, Installation & Adjustment of Limit Switch, Top Up (Differential Operation)
Removal