SL 600 (129.076) V12-6.0L (120.981) (1995)
1
Jack up vehicle at rear.
2
Unscrew drain plug (1) from transmission and drain off oil.
Installation Note
Tightening torque for drain plug 14 Nm.
3
Check oil level and correct.
4
Detach exhaust system at the plug connection (arrows) and remove with shielding plate.
5
Remove cross member (22) with rear engine mount.
6
Slacken retaining strap (21).
7
Unscrew exhaust support (34).
8
Unscrew cable (20) on kickdown solenoid valve (61). Unscrew bolt at pulse generator (24) and pull out pulse generator.
NOTE: In vehicles with mechanical speedometer, seal off shaft.
9
Unscrew flexible disk (25) on joint flange, slacken propeller shalt clamping nut and compress propeller shaft as much as possible.
Installation Note
Tighten propeller shaft clamping nut securely to 30 - 40 Nm.