SL 600 (129.076) V12-6.0L (120.981) (1995)
Knock in using a suitable drift.
15 Take out circlip (68) and knock out single-row deep-groove ball bearing (67).
Installation Note
There must be no clearance between the circlip (68) and the single-row deep-groove ball bearing (67). For this reason. circlips are available in 3
different thicknesses (2.0 - 2.1 - 2.2 mm).
When inserting the circlip ensure that it is correctly seated in the groove. If the circlip cannot be inserted, a thinner circlip must be used. If there is play
between the circlip and the single-row deep-groove ball bearing, a thicker circlip must be inserted.
Use a feeler gauge (0.10 mm) to check whether there is clearance.
16 Remove drive gear (129) for mechanical speedometer. Remove circlip (131) and take out shaft (130) and drive gear (129).