SL 600 (129.076) V12-6.0L (120.983) (1997)
Trailing Arm: Service and Repair
REMOVAL
Refer to the illustration during removal procedures.
-
Observe installed position of thrust arm cover before removal.
WARNING: Risk of accident when picking up a rear axle half, vehicle must not lift off platform surface
INSTALLATION
Reverse procedure to install, noting the following:
-
Replace self-locking hexagon bolts and nuts.
-
The rear axle shaft must be horizontal when the nuts are tightened
-
Remove wiring brackets (20d) if installed
-
Tighten the following components as noted:
-
Self-locking nut, thrust arm to rear axle carrier: 70 Nm
-
Self-locking nut, thrust arm to wheel carrier: 40 Nm