SLK 230 (170.447) L4-2.3L SC (111.973) (2000)
Relays and Modules - Wiper and Washer Systems: Technical Service Bulletins
Electrical - Electrostatic Discharge Damage Prevention
Date: March 23, 2011
Order No: S-B-54.00/238
SUBJECT: MY-All, All Models
Preventing Damage to Electronic Components Due to Electrostatic Discharge
Every contact and each physical separation of material or any movement of solid substance, fluids or particulate loaded gases can generate electrostatic
charges. Plastic generally produces the highest electrostatic charge.
The following electronic components listed as an example can be damaged by ESD:
- Airbag components
- Control units, in particular their bus connections: Control Area Network (data bus/CAN bus) (CAN), local interconnect network (LIN), etc.
- Antenna amplifier
- Receivers and displays (Radio, TV, GPS, telephone, etc.)
- Multifunction antenna assembly
- Avoidance of contact with electrostatic chargeable materials such as PE, PVC, Styrofoam.
- Use only original packaging or specially labeled and defined packaging and transport materials.
- Electronic components which have been removed must be put down on an ESD workplace. (Example: when swapping the painted cover from one
multifunction antenna to another, this must be performed on an ESD table mat (000 589 52 98 000).
- Touch connectors on electronic components and wiring harness on the housing only. Do not touch the pins and contacts!
- Electronic components must be installed before they are connected so that potential equalization with the body can take place.
Returning electronic components in warranty and goodwill cases:
When returning electronic components it is absolutely essential to observe the procedure and safety precautions listed in WIS doc.
AH54.00-P-0001-01A. Electrostatic charge or discharge means the original fault can be falsified or overlaid. This can lead to distorted faults symptoms
in the case of the fault analysis of the component concerned.