Colony Park V8-302 5.0L VIN F FI (1985)
Crankshaft Main Bearing Seal: Service and Repair
1984---88
A one piece crankshaft rear main oil seal must be used when replacement of seal required.
1.
Punch one hole into seal metal surface between seal lip and engine block using a suitable tool.
2.
Screw threaded end of suitable slide hammer into hole and remove seal. Use caution not to damage oil seal surface.
3.
Lubricate new seal with engine oil, then position seal on rear oil seal installer T82L-6701-A or equivalent.
4.
Position tool and seal on rear of engine, then install tool attaching bolts. Tighten attaching bolts alternately until seal is properly seated.