Cougar/XR7 V8-4.6L VIN W (1997)
Brake Caliper, Rear. Internal Park Brake Components
5. Position pin into caliper housing and in recess of parking brake lever shaft. Install seal on push rod. Insert push rod into push rod bore of caliper
housing. Make sure pin is positioned correctly in shaft recess and recess at end of push rod. Place locating washer over push rod so locating nib
fits into drilled locating hole in caliper housing. Install flat washer, right hand anti-rattle spring and spring retainer in sequence.
NOTE: Tools used in Steps 6 through 8 are part of Rear Caliper Spring Compressor Set T87P-2588-B, or equivalent set.
