Cougar/XR7 V8-4.6L VIN W (1997)
8. Apply Silicone Gasket and Sealant F6AZ-19562-AA or equivalent meeting Ford specification WSE-M4G323-A6 where engine front cover meets
cylinder blocks and crankshaft rear oil seal retainer meets cylinder blocks. Position oil pan on engine and install retaining bolts. Tighten bolts in
sequence shown to 20 Nm (14 ft. lbs.) then an additional 60 degrees) in no more than four minutes after applying sealer.
9. Position screw-type jackstand and block of wood under oil pan, rearward of oil pan drain hole.
10. Raise engine enough to remove wood blocks.
11. Lower engine onto front engine support insulator and remove jack.
12. Install front engine support insulator through bolts and tighten to 20-30 Nm (15-22 ft. lbs.).
NOTE: Two through bolts required on LH front engine support insulator and one through bolt required on RH front engine support insulator.
