Cougar/XR7 V8-4.6L VIN W (1997)
5. Install the Differential Side Bearing Puller T77F-4220-B1 on the A/C compressor. Place the tip of the puller forcing screw in the center pilot of
the shaft protector and the jaws of the puller around the back edge of the A/C clutch field coil.
NOTE: Pulley Puller D81P-19703-B or equivalent may be used as an alternative to T77F-4220-B1.
6. Tighten the puller forcing screw to pull the A/C clutch field coil from the A/C compressor head.
A/C Coil Pressing Tool - Installation
Installation
1. Clean the coil mounting surface on the front head to remove any dirt or corrosion.
CAUTION: Do not use air tools. The A/C clutch field coil can be easily damaged.
2. With the A/C compressor in a vertical position (nose up), place the A/C clutch field coil in position on the compressor front head. Make sure the
A/C clutch field coil electrical connector is positioned correctly as noted during removal.
3. Place the Coil Pressing Tool T89P-19623-EH with Field Coil Replacer T91L-19623-CH in position over the compressor nose and to the inner
radius of the A/C clutch field coil.
4. Position 2-Jaw Puller D80L-1002-L or equivalent on the A/C compressor and coil pressing tool. The jaws of the puller should be firmly engaged
with the rear side of the A/C compressor front mounts. The forcing screw must be piloted on the center mark of the pressing tool.
5. Tighten the forcing screw with a hand wrench until the A/C clutch field coil is pressed on the A/C compressor front head. Check to make sure that
the A/C clutch field coil bottoms against the head at all points around the coil outer diameter.
6. Install the A/C clutch pulley and A/C clutch on the A/C compressor.
7. Check and adjust air gap in Adjustments.
8. Install the A/C compressor on the vehicle.
