Cougar/XR7 V8-4.6L VIN W (1997)
INSTALLATION
1. Make sure the mounting surface is clean and that the O-ring is in proper location on crankshaft position sensor.
2. Position crankshaft position sensor and install retaining screw. Tighten to 8-12 Nm (71-106 lb in).
CAUTION: Do not overtighten retaining screw or damage to the sensor may occur.
3. Install A/C compressor. Evacuate and recharge A/C system.
4. Properly route engine control sensor wiring and connect electrical connectors to A/C compressor and crankshaft position sensor.
5. Lower vehicle.
6. Install serpentine drive belt.
7. Connect battery ground cable.