Cougar/XR7 V8-4.6L VIN W (1997)
Seat Belt Retractor: Service and Repair
Front Seat Belt, Retractor and Tongue
NOTE: Seat Belt Bolt Bit T77L-2100-A (No. 50 TORX) should be used for removal and installation of all safety belt assemblies.
REMOVAL
1. Remove front seat shoulder strap guide cover.
2. Insert Seat Belt Bolt Bit T77L-2100-A (No. 50 TORX) and remove front safety belt guide anchor bolt.
3. Remove safety belt anchor-to-sill bolt and rubber washer.
4. Snap out front shoulder belt bezel from panel. Leave front shoulder belt bezel on front safety belt retractor and tongue assembly.
5. Remove panel.
6. Remove safety belt anchor and bezel through slot in panel.
7. Remove safety belt retractor bolt.
8. Remove outboard front safety belt retractor and tongue from vehicle.
INSTALLATION
1. Make sure safety belt webbing is not twisted. If it is, remove the twist.
