Cougar/XR7 V8-4.6L VIN W (1997)
Voltage Regulator: Service and Repair
REMOVAL
1. Remove the four screws (T20 TORX (R)-type head) attaching the voltage regulator to the generator rear housing and bearing.
2. Remove the voltage regulator with generator brush and terminal holder attached, from the generator (GEN).
INSTALLATION
1. Install the voltage regulator and generator brush and terminal holder to the generator with attaching screws.
NOTE: Remove paper clip or equivalent from the voltage regulator.
2. Tighten screws to 2.3-3.4 N.m (21-30 lb-in).