Cougar/XR7 V8-4.6L VIN W (1997)
Deflector Gap
3. Install lubricant deflector using 1/8-inch Allen wrench. A gap of 5.08-6.35 mm (0.200-0.250 inch) must exist between deflector and back face of
axle housing cover.
CAUTION: If shield gap is not 5.08-6.35 mm (0.200-0.250 inch) it will cause vent leak and axle overheating.
4. Inspect rear axle hose for cracks and restrictions. Replace as required. Install rear axle hose.
5. Clean sealing surfaces and groove in axle housing cover.
NOTE: Make sure rear axle housing vent and brake and fuel line tubing are not plugged. When installing axle housing cover, insert open end of
brake and fuel line tubing into hole in crossmember.
