Cougar/XR7 V8-4.6L VIN W (1997)
9. Using a clean wool applicator, apply primer to inside glass edge 16 mm (0.6 inch) wide along top and sides and 70 mm (2.75 inches) wide along
bottom.
NOTE: Allow minimum of five minutes for glass primer to dry.
10. Apply an even bead of urethane WSB-M2G316-B around entire sheet metal pinch weld next to windshield moulding retaining leg. The bead
should be triangular in shape, 16 mm (0.625 inch) high and 8 mm (0.33 inch) at base. Apply two rows of urethane along cowl top.
NOTE:
-
Leave a door window slightly open until adhesive is cured.
-
Apply new urethane on top of existing material on pinch weld.
11. Install windshield assembly onto vehicle. This must be done before adhesive skins over.
12. Install retainers and moulding.
13. Remove spacer and install headliner, visors, windshield wiper arms, blades, and windshield garnish moulding.
14. Install cowl vent screens.
15. Install inside rear view mirror.
CAUTION:
-
Use only urethane for service of air and water leaks in urethane set windshield.
-
When replacing urethane installed glass parts, the vehicle should not be driven until the urethane has cured. At temperatures above 13°C
(55°F) and relative humidities above 50%, adequate cure time is typically 12 to 24 hours (less at higher temperatures and lower
humidities). See detailed instructions provided by the urethane manufacturer. Inadequate or improper curing may adversely affect the
retention of the windshield.
16. Check installation for air and water leaks in urethane seal.
17. Install windshield outside moulding.
