Grand Marquis V8-4.6L Flex Fuel (2010)
Arm Rest: Removal and Replacement
Seat Armrest - Rear
Removal and Installation
1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in
Vehicle Jacking and Lifting. Failure to follow the instructions may result in serious personal injury.
For police vehicles equipped with a fire suppression system, depower the system.
2. Remove the rear seat cushion and backrest. For additional information, refer to Seat - Rear See: Seats/Service and Repair/Seat - Rear.
3. Remove the 4 nuts.
-
To install, tighten to 5 Nm (44 lb-in).
4. Remove the armrest.
5. WARNING: The retaining wires in the rear seat cushion foam pad and frame, and rear seat backrest foam pad and frame must be fully
seated in the retainer brackets to prevent the seat backrest and seat cushion from sliding forward in the event of a crash. Failure to follow
these instructions may increases the risk of serious personal injury or death in a crash.
NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Vehicle Jacking and Lifting. Failure to follow these instructions may result in serious personal injury.
For police vehicles equipped with a fire suppression system, repower the system.
