Grand Marquis V8-4.6L Flex Fuel (2010)
5. Remove the wheel stud.
Installation
1. NOTE: Make sure to use washers that have an ID that is larger than the OD of the wheel stud serrations. Use enough washers (approximately 4)
to allow the wheel stud to fully seat against the hub flange.
Install the wheel stud.
1. Install 4 washers onto the wheel stud.
2. Install the wheel nut. Tighten the wheel nut until the wheel stud seats fully onto the wheel hub flange.
2. Remove the wheel nut and washers.
3. Install the brake disc.
4. Position the caliper and anchor plate assembly onto the steering knuckle, and install the bolts.
-
To install, tighten to 160 Nm (118 lb-ft).
5. Install the wheel and tire. For additional information, refer to Wheels and Tires.
6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Vehicle Jacking and Lifting. Failure to follow these instructions may result in serious personal injury.
If equipped with a fire suppression system, repower the system.
