Grand Marquis V8-4.6L SOHC VIN W (2005)
Steering Gear: Service and Repair
Steering Gear
Removal and Installation
NOTE: New O-ring seals must be installed any time the lines are disconnected from the steering gear.
1. WARNING: The electrical power to the air suspension system must be turned off prior to hoisting, jacking or towing an air suspension
vehicle. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during
these operations.
Turn the air suspension service switch off.
2. Hold the steering wheel in the straight-ahead position using a suitable holding device.
3. CAUTION: Do not allow the intermediate shaft to rotate while it is disconnected from the steering gear or damage to the clockspring can result.
If there is evidence that the intermediate shaft has rotated, the clockspring must be removed and recentered. Refer to Air Bag Systems.
From the engine compartment, remove the bolt and detach the intermediate shaft from the gear.
4. Remove the wheel and tire assemblies.
5. NOTE: The hex holding feature can be used to prevent turning of the stud while removing the nut.