LN7 L4-98 1.6L SOHC VIN 4 2-bbl HP (1983)
FIGURE 4
8.
Position the camber wedge between the shock strut and the spindle at the upper attaching hole location. The teeth on the camber wedge are to face
outward (Figure 4).
9.
Install upper bolt (small) M10 from the rear and hand start the nut M10. DO NOT tighten at this time.
10.
Pull the top of the brake drum and spindle out as far as it will go and lightly tap down the camber wedge in place.
11.
Torque the upper nut (M10) to 60-65 lbs. ft. and the lower nut (M12) to 96 lbs. ft.
12.
Install the brake hose bracket.
13.
Install the brake hose clip.
14.
Install the wheel and tire assembly.
15.
Remove the jack stands and lower the vehicle.
Camber Specification
