LN7 L4-98 1.6L SOHC VIN 4 2-bbl HP (1983)
Figure 4
3.
Attach a DVOM, Rotunda No. 014-00407, or equivalent, on 20 V scale. Connect ( + ) to pin 47 and (-) to pin 46 (Figure 4).
4.
Turn ignition key to "RUN" position (do not start engine).
5.
Adjust TP Sensor (rotate) until the DVOM reads 1.0 V (0.9-1.1).
6.
Tighten TP Sensor screws to 1.2-1.8 N-m (11-16 in.lb.).
7.
While watching the DVOM, move the throttle to wide open and back to idle position. For proper operation, the DVOM should move from 1.0 to
at least 4.0 and back to 1.0 V.
8.
Perform EEC IV Quick Test (Section 16, Emission Diagnosis Manual).
9.
Verify satisfactory engine operation by drive evaluation.
10.
Remove Breakout Box.
PART NUMBER
PART NAME
CLASS
E4ZZ-9B989-B
Throttle Position Sensor Kit
B
(w/gasket)
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.