Mariner 2WD L4-2.3L VIN H Hybrid (2006)
Connector Views show the views of the pins and/or cavities of all connectors. The pin and cavity sides are shown separately as if the connector were
disconnected. The color of the connector housing is indicated next to the connector number when available. The harness causal number is located
above the connector view and below the connector number. The circuit function charts are located below each connector. The wiring harness
designations are listed in Component Location Charts.
WARNINGS
-
Always wear safety glasses for eye protection.
-
Use safety stands whenever a procedure requires being under a vehicle.
-
Be sure that the IGNITION SWITCH is always in the OFF position, unless otherwise required by the procedure.
-
Set the parking brake when working on any vehicle. An automatic transmission should be in PARK. A manual transmission should be in
NEUTRAL.
-
Operate the engine only in a well-ventilated area to avoid danger of carbon monoxide.
-
Keep away from moving parts, especially the fan and belts, when the engine is running.
-
To prevent serious burns, avoid contact with hot metal parts such as the radiator, exhaust manifold, tail pipe, catalytic converter and muffler.
-
Do not allow flame or sparks near the battery. Gases are always present in and around the battery set. An explosion could occur.
-
Do not smoke when working on a vehicle.
-
To avoid injury, always remove rings, watches, loose hanging jewelry and avoid wearing lose clothing.
-
This vehicle is equipped with high voltage cables, components, and wiring. The high voltage warning labels containing the high voltage symbol
are located on each high voltage component. High voltage cables, and wirings are orange in color. Certified rubber insulating gloves and a face
shield must be worn when working with the high voltage cables, components, or wiring. The ignition key must be cycled to the off position for a
minimum of 5 minutes, and the high voltage traction battery service disconnect plug placed in the servicing/shipping position before
disconnecting the high voltage cables. Failure to follow these instructions may result in personal injury or death.
-
Do not disconnect, disable, or touch the high voltage cables, components, or wiring during the module reprogramming procedure because high
voltage is present. The high voltage warning labels containing the high voltage symbol are located on each high voltage component. High voltage
cables, and wiring are orange in color. Failure to follow these instructions may result in personal injury or death.
-
The nominal high voltage traction battery voltage is 330 volts DC. The buffer zone must be set up and high voltage insulated safety gloves and a
face shield must be worn. Failure to follow these instructions may result in personal injury or death.
-
The high voltage traction battery and charging system contains high voltage components and wiring. High voltage insulated safety gloves end a
face shield must be worn when carrying out any diagnostics on this vehicle. Failure to follow these instructions may result in personnel injury or
death.
-
Before carrying out any removal and installation procedures of the high voltage traction battery system, the high voltage traction battery must be
depowered. Failure to follow these instructions may result in personal injury or death.
-
The high voltage insulated safety gloves are to be worn while working on the high voltage system should be of the appropriate safety and
protection rating for use on the high voltage system. They must be inspected before use and must always be worn in conjunction with the leather
outer glove. Any hole in the rubber insulating glove is a potential entry point for high voltage. Failure to follow these instructions may result in
personal injury or death.
-
High voltage insulated safety gloves and a face shield must be worn when working with high voltage cables. The ignition switch must be OFF for a
minimum of 5 minutes before removing high voltage cables. Failure to follow these instructions may result in personal injury or death.
-
The buffer zone is required when working with the high voltage system. Failure to follow these instructions may result in personal injury or death.
Symbols