Mariner 2WD L4-2.5L (2009)
18. Remove the OCS.
-
Pull all the OCS components (hose, pressure sensor, wire harness, OCSM and connectors) through the seat cushion frame opening.
Assembly
All seats
1. Bend the retaining tab back on the pressure sensor component bracket.
Seat with original equipment OCS system
2. NOTICE: Failure to route the seat Occupant Classification Sensor (OCS) components through the correct seat cushion support opening
can cause component failure.
NOTICE: While positioning the seat cushion frame and Occupant Classification Sensor (OCS), be careful not to damage any of the
components. Failure to do so can result in component failure.
Feed the OCS system components (pressure sensor and hose) through the opening in the seat cushion frame.
3. Align the OCS bladder to the seat cushion frame.
4. Install the 2 pin-type retainers to the OCS bladder and seat cushion frame.
5. NOTE: Make sure the pressure sensor hose is not kinked during installation.
Install the pressure sensor onto the seat cushion frame bracket, making sure the retaining tab is completely engaged.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
6. Slide the OCSM into the seat cushion frame bracket and install the rivets.