mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2815 > < Initial Inspection and Diagnostic Overview|Page 2813
Page 54
background image

S14 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE RCM DISCONNECTED

-

Disconnect: RCM C2041b.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to S15.

No

CONNECT the negative battery cable. GO to S34.

-------------------------------------------------
S15 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE OCSM DISCONNECTED

-

Disconnect: OCSM C3285.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), GO to S16.

If the vehicle is not equipped with an APIM, GO to S17.

No

CONNECT the negative battery cable. GO to S35.

------------------------------------------------
S16 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE APIM DISCONNECTED

-

Disconnect: APIM C3338.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to S17.

Initial Inspection and Diagnostic Overview|Page 2815 > < Initial Inspection and Diagnostic Overview|Page 2813