Mariner 2WD L4-2.5L (2009)
-
Ignition ON.
-
Measure the voltage between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit VDB07
(VT/OG), harness side and ground.
-
Is the voltage greater than 6 volts?
Yes
REPAIR the circuit. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The CAN has tested within specifications. Go To Pinpoint Test T to diagnose the intermittent MS-CAN fault. See: Pinpoint Test T: Intermittent No
Medium Speed Controller Area Network (MS-CAN) Communication, Communication Can Be Intermittent
-------------------------------------------------
U5 CHECK THE MS-CAN TERMINATION RESISTOR
-
Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.
-
Is the resistance between 108 and 132 ohms?
Yes
GO to U6.
No
GO to U9.
-------------------------------------------------
U6 CHECK THE MS-CAN TERMINATION RESISTOR WITH THE SJB DISCONNECTED
-
Disconnect: Smart Junction Box (SJB) C2280b.
-
Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.
-
Is the resistance between 108 and 132 ohms?
Yes
GO to U7.
No
GO to U8.